Welcome To Extreme HHO
Shortly after we began experimenting with HHO we realized that conventional electrolysis would only take us so far. We designed many different HHO Generators, some with Stainless Steel tubes and some with Stainless Steel Plates. We tried almost every electrolyte possible, from Sodium Hydroxide and Pottasium Hydroxide to Ammonia and Baking Soda. We experimented with the effects of vacuum on Hydrogen production as well as the effects of heat. We took pages and pages of notes and compared them with others.
It wasn't as simple as we thought.
We had numerous problems, most notably with controlling amperage and heat. We immediately noticed the terminals at our HHO Cell became incredibly hot and left uncontrolled, it would melt the container. We also found that it was impossible to mix our HHO electrolyte correctly given the effects temperature has on amperage.
Regardless of the electrolyte concentration, the end result was always the same. The longer the HHO Generator ran, the more amperage it consumed and the more heat it created.
So, having experience in electronics, it became apparent we needed a Pulse Width Modulator for our HHO System.We experimented with many different frequencies and designs of HHO Pulse Width Modulators, just as Stanley Meyer did and settled on the HHO PWM that worked best with minimal maintenance and tweaking.
The Pulse Width Modulators you see on this site have been carefuly designed to give you absolute control over your HHO Generator. The overheating of the terminals as well as the HHO electrolyte are a thing of the past.
If you bought a Hydrogen Generator for your car, you probably paid a nice penny for it. If you built your own, then you know how time consuming it can be. Either way, you have a lot invested. Installing an HHO PWM is the best way to protect your investment.
This 30 Amp Heavy Duty HHO PWM comes with the following features:
- 30 Amp Illuminated Analog Amperage Gauge with Shunt and Dimmer Control Knob
- High Speed Built In Cooling Fan Keeps the PWM Cool- ( PWM's tend to get hot )
- Front Facing Controls
- Variable Power Output LED- Intensity of LED Increases With Amperage
- Built In 30 Amp "Push to Rest" Type Circuit Breaker- No more replacing burnt fuses!
- Easy To Install- Takes Less Than 10 Minutes
- Small Enough To Fit Right On The Dash- Only 6x3x2
- Lighted Green Power Switch
- Built In 50 Amp Relay
- Free Tech Support- We back our products with not only an email, but also our phone number!
Note: We only have a limited number remaining. Once our stock is depleted this item will no longer be available for sale.
Only $135
FREE SHIPPING
